Removing Control Unit For Convertible Top

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information

If the control unit for the convertible top must be replaced, first the values must be read from the control unit using the PIWIS Tester 9718 . → 619619 REMOVING AND INSTALLING CONVERTIBLE TOP CONTROL UNIT - chapter on "Programming"

Unscrew both fastening screws -1- for the convertible top control unit.

Fig 1: Removing Convertible Top Control Unit Fastening Screws
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Remove control module, disengage the connector housing -arrow A- to the right, and pull it down and off. Press plug connection -arrow B- together and pull it down and off. Disengage plug connection -arrow C- upward and to the right, and pull it down and off.

Fig 2: Removing Electrical Connector
Courtesy of PORSCHE CARS NORTH AMERICA, INC.