Removing Pneumatic Spring At The Hinge Side
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Incorrect handling of gas-filled shock absorbers
- Gas-filled shock absorbers can burst
- Risk of eye injuries
- Risk of bruising
→ Gas-filled shock absorbers must be in idle state before removal.
→ Open the lid.
→ Secure the lid to prevent it from closing accidentally following removal of the gas-filled shock absorbers.
→ Do not use force to open the gas-filled shock absorbers because of their high internal pressure.
Information
- Some of the repair illustrations show only one side of the vehicle.
- Naturally, some steps also have to be performed on the opposite side of the vehicle as well.
- These must be carried out as a mirror image of the steps shown.
- Loosen the pneumatic spring.
- 1.1. Insert a screwdriver between the head of the pneumatic spring -1- and the safety clip.
- 1.2. Lift up the safety clip by levering the screwdriver towards the rear -arrow A- . The safety clip remains on the head of the pneumatic spring -1- .
- 1.3. Pull the pneumatic spring off the ball joint -arrow B- .
- 1.4. Remove the screwdriver.