Disassembling Hood Compartment Lid

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information

The foam pad/foam part will be damaged irreparably during removal and cannot be re-used.

Remove foam pad.

Fig 1: Removing Foam Pad
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 1.1. Loosen foam pad -1- in bonding area -A- and pull off from hood compartment lid -2- (-arrows- ).
2. 1.2. Remove adhesive residue and clean with cleaning solution.
  
  Fig 2: Identifying Adhesive Bonding Area
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Remove edge protection.

Fig 3: Removing Protective Edging
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 2.1. Mark position of retaining clips -1- and remove -arrow A- .
2. 2.2. Pull off edge protection -2- from hood compartment lid -3- (-arrow B- ).
Remove rubber buffer at the left and right.

Fig 4: Removing Rubber Buffer
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 3.1. Unscrew rubber buffer -1- out of hood compartment lid -2- (-arrow- ).
Remove upper part of lid lock.

Fig 5: Removing Lid Lock Upper Part
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 4.1. Unscrew fastening screws -1- .
2. 4.2. Remove upper part of lid lock -2- from hood compartment lid -3- .
Remove bracket at the left and right.

Fig 6: Removing Bracket
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 5.1. Press in retaining pins and unclip expanding clips -1- .
2. 5.2. Remove bracket -2- from hood compartment lid -3- (-arrow- ).
Information

The sealing strip and seal cannot be reused.
Remove seal and sealing strip.

Fig 7: Removing Seal And Sealing Strip
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 6.1. Pull off sealing strip -1- together with seal -2- from hood compartment lid -3- (-arrow- ).
2. 6.2. Pull off adhesive tape -1- from hood compartment lid -2 - at the left and right -arrow- .
  
  Fig 8: Removing Adhesive Tape
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
3. 6.3. Remove adhesive residue and clean with cleaning solution.
  
  Fig 9: Cleaning Adhesive Bonding Area
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.