Installing Potentiometer

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Install and lock new contacts of the potentiometer lines. To do this, compare the assignment with the wiring diagram.
1. 1.1. Install the new contacts of the potentiometer in the same position as follows:
2. 1.2. Green wire (pin 1) to pin 9
3. 1.3. Yellow wire (pin 2) to pin 4
4. 1.4. Red wire (pin 3) to pin 8
5. 1.5. Close the secondary lock of the plug connection with a small screwdriver again.
Winding insulating tape around wires
Tighten potentiometer with both fastening screws.

Fig 1: Installing Potentiometer
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Route the electric plug connection and engage.