Preliminary Work

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

→ 6101IN HOOD IN SERVICE POSITION

Partly remove hood covering.

Remove tension rope on hood covering.

Fig 1: Removing Hood Covering Tension Rope
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 1.1. On the tension rope eye -1- , unscrew the fastening screw -2- .
Remove seals and retaining frame at sides of roof frame.

Fig 2: Removing Seals And Retaining Frame
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 2.1. Pull the lower seal -1- out of the profile of the retaining strip -2- .
2. 2.2. On the upper seal -3- with the retaining rail -2- , unscrew the fastening screws -4- and remove the seal -3- and the retaining rail -2- from the roof frame.
Remove retaining strip and hood seal on roof frame 1.

Fig 3: Removing Retaining Strip And Hood Seal
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 3.1. Unscrew and remove fastening screws -1- from the retaining strip -2- .
2. 3.2. On the hood seal -3- , unscrew the fastening screws -4- .
3. 3.3. Pull hood seal -3- at the left and right forward out of roof frame 1.
Remove hood covering at sides of roof frame 1.

Fig 4: Removing Sides Roof Frame 1 Hood Covering
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 4.1. On the roof frame -1- , unscrew the fastening screws -2- and lift the shaped sheetmetal part -3- with the hood covering.
Remove hood covering at front on roof frame 1.

Fig 5: Removing Hood Covering
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 5.1. Detach hood covering at front on roof frame 1 and lay it down to the rear.