LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 104 (61 - Convertible Top, Hardtop -- CARRERA (997)) >> WM 614219 Removing And Installing Rear Side Section Flap (CABRIO Models) >> Subsequent Work

Subsequent Work

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install hardtop mounting. → 611719 REMOVING AND INSTALLING MOUNTING FOR HARDTOP  - section on "Installing"
  2. Perform drive link test on rear side section flap using PIWIS Tester II 9818  .
  3. Calibrate convertible top. → 6101K2 K2 -CALIBRATING CABRIOLET CONVERTIBLE TOP 
  4. Check gap dimensions of rear side section trim panel and make adjustments if necessary. → WM 706819 REMOVING AND INSTALLING C-PILLAR TRIM - section on "Adjusting" 
scientia non olet · About LEMON Manuals