Installing Styling Frame

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Install styling frame on roof frame 3.

Fig 1: Installing Styling Frame On Roof Frame 3
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 1.1. Secure air deflector -1- on the back of the styling frame -2- with the fastening screw -3- . → Tightening torque: 1.7 Nm (1.5 ft. lb.)
2. 1.2. Position styling frame -2- on roof frame (3) -4- and secure with the fastening screws -5- (-arrow- ). → Tightening torque: 1.7 Nm (1.5 ft. lb.)
Install styling frame 2 on roof frame 2.

Fig 2: Installing Styling Frame On Roof Frame 2
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Information

Coat fastening screws 7 for styling frame 2 with Loctite 243 .
1. 2.1. Position styling frame (2) -1- on roof frame (2) -2- .
2. 2.2. Adjust gap between styling frame (2) -1- and styling frame (3) -3- and secure with the fastening screws -4- and washers -5- . → Gap dimension: 3.1 mm +0.5 mm → Tightening torque: 10 Nm (7.5 ft. lb.)
Install seal on styling frame (3).

Fig 3: Installing Seal On Styling Frame (3)
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 3.1. Position aluminum profile -1- on styling frame (3) -2- and secure with the fastening screws -3- (-arrow- ). → Tightening torque: 1.7 Nm (1.5 ft. lb.)
2. 3.2. Insert seal -4- into the aluminum profile -1- .
Install seal on styling frame (2).

Fig 4: Installing Seal On Styling Frame (2)
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 4.1. Position aluminum profile -1- on styling frame (2) -2- and secure with the fastening screws -3- (-arrow- ). → Tightening torque: 1.7 Nm (1.5 ft. lb.)
2. 4.2. Insert seal -4- into the aluminum profile -1- .