Removing Seal For Cowl Panel Frame

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Panel Frame Installation Position

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Unscrew fastening screw -1- and pull off rubber seal for door -2- on the left and right as far as the door hinge.

Fig 2: Loosening Rubber Seal For Door
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Drill out rivets -1- from the integrated sheetmetal strips of the seal for the cowl panel frame -2- on the left and right using a 4 mm drill bit.

Fig 3: Loosening Cowl Panel Frame Seal
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Pull seal for cowl panel frame -1- off the sheetmetal flange on the cowl panel frame.

Fig 4: Removing Cowl Panel Frame Seal
Courtesy of PORSCHE CARS NORTH AMERICA, INC.