Installing Seal For Cowl Panel Frame

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Place seal for cowl panel frame -1- on the sheetmetal flange on the cowl panel frame.

Fig 1: Installing Cowl Panel Frame Seal
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Position seal for cowl panel frame -2- at the left and right and secure with new rivets -1- .

Fig 2: Identifying Cowl Panel Frame Seal
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Information

Make sure that the water drain is not trapped.
Press rubber seal for door -2- at the left and right onto the sheetmetal flange and slide in sheetmetal insert -Inset- .

Fig 3: Securing Door Rubber Seal
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Tighten fastening screw -1- . → Tightening torque: 6 Nm (4.5 ft. lb.)