Removing Bracket For Hardtop Mount

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Hardtop Mount Bracket Installation Position

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Information

Only when removing the left bracket for hardtop mount.

Press in locking tabs -Arrows A- and pull electric plug connection -1- up and off -Arrow B- .

Fig 2: Removing Bracket For Hardtop Mount
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Unscrew fastening screws -2- inside and remove the retaining angle -3- .
Unscrew fastening screws -2- outside and remove bracket for hardtop mount -4- upwards out of the frame of roll-over protection system -5- .