Installing Bracket For Hardtop Mount

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Hardtop Mount Bracket Installation Position

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Position bracket for hardtop mount -4- on frame for roll-over protection system -5- and screw down the fastening screws -2- on the outside. Tightening torque → Tightening torque: 9.7 Nm (7.2 ft. lb.)

Fig 2: Installing Bracket For Hardtop Mount
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Position retaining angle -3- on frame for roll-over protection system -5- and screw down with the fastening screws -2- on the inside. Tightening torque → Tightening torque: 9.7 Nm (7.2 ft. lb.)
Information

Only when removing the left bracket for hardtop mount.
Press in electric plug connection -1- until it audibly engages.