Installing Convertible-Top Peg Mount

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Convertible-Top Peg Mount Installation Position

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Place convertible-top peg mount -1- on windscreen frame from below -arrow A- , position it correctly and screw down hand-tight using the fastening screws -2- .

Fig 2: Installing Convertible-Top Peg Mount
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
To position convertible-top peg mount, close convertible top or fit hardtop.
Move convertible-top peg mount as far as possible outwards (towards the centering journal) -arrow B- and screw down. Tightening torque → Tightening torque: 10 Nm (7.5 ft. lb.)
Position cap -3- from below -arrow C- and clip into place.