Installing Hood Inner Lining At Rear

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Secure hood inner-lining joint to the rear window.

Fig 1: Securing Hood Inner-Lining Joint To Rear Window
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 1.1. Raise the metal clips using a plastic spatula -arrow A- and insert a small screwdriver under the metal clips -arrow B- .
2. 1.2. Insert the joint seal -1- for the hood inner lining under the metal clips -arrow C- .
  Check that the clearance cuts of the hood inner lining -D- are positioned at the electric connection for the rear window.
3. 1.3. Tap in the metal clips using a plastic hammer. Make sure that the metal clips engage in the frame cutouts.
Press the hood inner-lining joint into the groove on the tension bow -arrows- .

Fig 2: Pressing Hood Inner-Lining Joint
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Insert brace -1- at the left and right into the textile case on the hood inner lining -2- . First, insert the brace into the tension bow at the rear -arrow A- , then bend it through -arrow B- and guide it forward -arrow C- .

Fig 3: Installing Brace
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Pull hood covering bracing strap -3- through the cut-out in the hood inner lining and use the fastening screw -2- to secure to the corner bow -1- .

Fig 4: Identifying Hood Covering Bracing Strap
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Close the Velcro fastener at the left and right on the tension bow -arrow- .

Fig 5: Closing Velcro Fastener
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Press on snap fastener at the left and right -arrow- .

Fig 6: Pressing Snap Fastener
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Close the zip -2- between the hood inner lining at the rear -3- and the joint in the hood covering -1- in -direction of arrow- .
Lock the zip using a paper clip -4- .

Fig 7: Closing Zip
Courtesy of PORSCHE CARS NORTH AMERICA, INC.