Removing Convertible-Top Inner Lining

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Convertible-Top Inner Lining Installation Position

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Unclip convertible-top inner lining -1- from the roof frame bar -2- at the front and in the middle, starting at the outside and moving downwards -arrows- .

Fig 2: Disengaging Convertible-Top Inner Lining
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Loosen bracing strap at the left and right.

Fig 3: Loosening Bracing Strap
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 2.1. Unscrew fastening screw -1- from the bracing strap -2- (-arrow A- ).
2. 2.2. Remove bracing strap -2- from the fastening clip -3- .
3. 2.3. Unscrew fastening screw -4- on the deflector -5- (-arrow B- ) and counter the fastening nut -6- on the back while doing this.
Loosen convertible top rooflining at the left and right.

Fig 4: Loosening Convertible Top Rooflining
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 3.1. Undo fastening screw -1- on the guide rail for the main folding top bow -2- (-arrow A- ).
2. 3.2. Loosen the convertible top rooflining fabric plate -3- and convertible top covering bracing strap -4- (-arrow B- ).
Disconnect convertible-top inner lining close to the main folding top bow -1- by opening the zip -2- in -direction of arrow- and detach it from the convertible top covering -3- .
Release the zip using a paper clip -4- .

Fig 5: Opening Convertible Zip
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Remove convertible-top inner lining.