Installing Convertible-Top Inner Lining

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Close the zip -2- between the convertible-top inner lining at the front -1- and the joint in the convertible top covering -3- in -direction of arrow- .
Lock the zip using a paper clip -4- .

Fig 1: Closing Zip Fastener
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Secure the convertible top rooflining at the left and right.

Fig 2: Securing Convertible-Top Inner Lining
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 2.1. Position the convertible top rooflining fabric plate -3- in front of the guide rail -2- and position the bracing strap -4- between the guide rail and the main folding top bow -arrow A- .
2. 2.2. Tighten the fastening screw -1- on the main folding top bow -arrow B- . → Tightening torque: 2 Nm
Secure the bracing strap at the left and right.

Fig 3: Securing Bracing Strap
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 3.1. Position the deflector -5- on the corner bow joint -arrow A- and secure with the fastening screw -4- and fastening nut -6- .
2. 3.2. Pull bracing strap -2- through the fastening clip -3- -arrow B- .
3. 3.3. Secure the bracing strap -2- to the C-pillar with the fastening screw -1- .
Secure convertible-top inner lining.

Fig 4: Securing Convertible-Top Inner Lining
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 4.1. Always replace clips -2- .
2. 4.2. Affix strips of adhesive tape -4- to the roof frame bar.
3. 4.3. Clip convertible-top inner lining -1- at the center and front onto the roof frame bar -3- , starting from the inside and moving upwards.