Tools And Materials
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
The following fixture is required for assembly work on the outer area:
| Item | Designation | Explanation |
|---|---|---|
| G | Wall support for 911 Carrera Cabriolet hardtop | → "Special tool" |
The following tools and materials are required to construct the fixture for work in the inner area:
| Item | Designation | Explanation |
|---|---|---|
| Drill | ||
| Drill bit 6 mm | ||
| Drill bit 3 mm | ||
| Sabre saw | ||
| Measuring tape | ||
| B | Support cheek (2x) | Multiplex plate 25 mm thick, 600 x 120 mm |
| C | Swivel arm 1x) | Multiplex plate 25 mm thick, 550 x 200 mm |
| D | Base plate (1x) | Wood-core plywood 19 mm thick, 1500 x 900 mm |
| E | Horizontal banner arm (1x) | Hardwood block 30 mm thick, 650 x 50 mm |
| F | Base (1x) | Hardwood block 50 mm thick, 90 x 140 x 190 mm |
| All materials listed are commercially available. | ||
| Mounting component 9620 | → "Special tool " | |
| Set of fittings includes: | ||
| A1 | Retaining bracket (1x) | |
| A2 | Hinge (1x) | |
| A3 | Base (2x) | |
| A4 | Straight pin 6 M6 x 40 (6x) | |
| A5 | Countersunk screw 4.5 x 20 (8x) | |
| A6 | Countersunk screw 6 x 20 (2x) | |
| A7 | Countersunk screw 6 x 20 with disc (4x) | |
| A8 | Countersunk screw 6 x 60 (2x) | |
| A9 | Countersunk screw 6 x 50 (3x) | |