Making Swivel Arm

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Make swivel arm -C- with basic material Multiplex plate 550 x 200 mm, 25 mm thick.

Fig 1: Identifying Swivel Arm Dimension

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

-A1- = Retaining bracket
-A2- = Hinge
-A5- = countersunk screw 4.5 x 20
-A6- = countersunk screw 6 x 20
-C- = Swivel arm

Work procedure:
1. 1.1. Fit retaining bracket -A1- with 2 countersunk screws -A6- following the dimensions specified on the swivel arm -C- .
2. 1.2. Fit hinge -A2- with 4 countersunk screws -A5- following the dimensions specified on the swivel arm -C- .