Fitting Swivel And Support Cheeks On The Basic Plate

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Basic material: Wood-core plywood 1500 x 900 mm, 19 mm thick

Fig 1: Identifying Swivel And Support Cheeks Dimensions

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

-A3- = Base
-B- = Support cheek
-C- = Swivel arm
-D- = Base plate

Work procedure:
1. 1.1. During assembly, all parts are positioned from the center!
2. 1.2. Measure and mark the plate -D- .
3. 1.3. Fasten completed swivel arm -C- on the hinge -A2- with four 4.5 x 20 countersunk screws in accordance with the dimensions specified on the plate -D- .
4. 1.4. Transfer hole pattern of the support cheeks -B- onto the base plate -D- in accordance with the specified dimensions, and drill holes using a 6-mm drill bit.
5. 1.5. Fit support cheeks -B- over the prefitted straight pins -A4- onto the plate -D- .