Disassembling Hardtop
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
- Detach cover strips and roof strip clips.
- 1.1. Lift up the cover strip -1- at left and right using a plastic spatula and pull it off. The roof strip clips are destroyed on removal.
- Place outer roof panel of hardtop on the assembly fixture.
- Unclip linings.
- 3.1. Unclip linings -1- front and rear from hardtop -2- .
- Detach seal at sides of roof frame.
- 4.1. The seal at the sides of the roof frame -1- is in two parts. Pull the upper seal -2- out of the profile of the retaining strip -3- .
- 4.2. Unscrew fastening screws -4- from the retaining strip -3- .
- 4.3. Remove the seal below together with the retaining strip -5- from the roof frame -1- .
- Loosen and detach retaining strip and roof frame seal.
- 5.1. Unscrew tapping screws -1- from retaining strip -2- .
- 5.2. Unscrew pan-head screw -3- from the roof frame seal, detach the seal at the corners and remove it.
- Pull off sealing rubber.
- 6.1. Pull off the surrounding sealing rubber -1- to the rear and pull it out at the ends from the roof frame seal -2- .
- Detach roof liner at front.
- 7.1. Lift front retaining strip -1- of roof liner -2- with a plastic spatula and pull it off.
- Detach roof liner at sides.
- 8.1. Lift up the roof liner -1- on the left and right sides with a plastic spatula and disengage from the sheetmetal clips -2- .
- Detach roof liner at rear and transverse struts.
- 9.1. Pull plastic strip -2- of roof liner to the rear and detach it -1- .
- 9.2. Pull out transverse struts -3- with plastic sleeves -4- and remove the roof liner -1- .
- Loosen sound absorber from the hardtop body.
- 10.1. Loosen the sound absorber -2- of the hardtop body -1- using a spatula.
- Remove foam strips.
- 11.1. Carefully pull off foam strips -1- on B-pillar -A- , at rear of roof -B- and at the centering pegs at front -C- and the foam pads -2- on the left and right.
- Remove locking lever.
- 12.1. Unscrew and remove fastening screws -1- from the locking lever -2- .
- Press expander nuts out of the hardtop body.
- 13.1. Press expander nuts -1- out of the hardtop body -2- at the sides and top.