Low-Maintenance Battery

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Battery terminals do not need to be greased.
The battery terminal clamps should only be attached manually, without excessive force, to prevent damage to the battery housing.
The tightening torque for the battery terminals is 5 Nm (3.5 ftlb.).
If the battery is reconnected, proceed according to → 2706IN WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY .
To ensure that the battery does not leak, it is essential to ensure that the original plugs supplied with the battery are screwed into the battery openings.
In the event of loss or damage, only original plugs of the same design should be used.
The plugs must be fitted with an O-ring seal.