Installing Ignition Coils

Install ignition coil -1- .
1. 1.1. Insert ignition coil as far as it will go.
2. 1.2. Tighten screw -3- .
  Tightening torque 10 Nm (7.5 ftlb.)
3. 1.3. Connect electric connector -2- . When doing so, make sure you hear it latching into place and check that it is firmly seated by pushing it up.
  
  Fig 1: Identifying Ignition Coils Screws
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.