Removing Vibration Damper
- Remove heat shield on the engine carrier.
- 1.1. Unscrew three external Torx screws (M6 x 12) and remove heat shield.
- Position vibration damper -1-
for removal.
- 2.1. Turn the vibration damper clockwise using special tool turning device 9773 -3-
until one staking bore is flush with the bore in the crankcase.
- 2.2. Stake the vibration damper using one of the locating pins 9595/1 -4-
.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Unscrew fastening screw -10-
and remove dowel sleeve -11-
.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Remove vibration damper.
- 4.1. Unscrew six external Torx screws (M8 x 1 x 25) -2-
and carefully guide the vibration damper out through the engine carrier.
- 4.2. Check the vibration damper and dowel pin for damage (e.g. cracks, deformation) and replace components if necessary.
- 4.3. Replace screws.