LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 10 - Engine - Crankcase, Suspension -- 911 CARRERA (991) >> WM 105519 Removing And Installing Oil Separator (Except CARRERA "Edition", CARRERA Cabriolet "Edition", CARRERA 4 "Edition", CARRERA 4 Cabriolet "Edition", Gt3, Gt3 RS) >> Installing Oil Separator

Installing Oil Separator

  1. Remove adhesive tape or stoppers from the bores.
  2. Replace O-rings and grease with Kluber Syntheso Glep (Porsche part number 000.043.204.68).
  3. Install oil separator.
    1. 3.1. Fit oil separator into the bracket for the oil/water heat exchanger.
    2. 3.2. Fit and tighten two screws. Tightening torque 10 Nm (7.5 ftlb.) 
    3. 3.3. Fit engine vent line on the oil separator and check that it is seated securely.
  4. Metric screws (M6 x 25) can also be used as an alternative to the standard self-tapping screws.

    Tightening torque 13 Nm (9.5 ftlb.) 

  5. Clip in electric line for starter.
scientia non olet · About LEMON Manuals