Installing Bracket For Oil-Water Heat Exchanger

Remove stoppers from the bores.
Grease new O-rings with Kluber Syntheso Glep (Porsche Part No. 000.043.204.68) and fit them.
Install bracket -1- for oil/water heat exchanger.
1. 3.1. Position the bracket and check that the O-rings are seated correctly.
2. 3.2. Fit and tighten six M6 x 45 screws -2- and one M6 x 60 screw -1- . Tightening torque 13 Nm (9.5 ftlb.)
  
  Fig 1: Identifying Oil/Water Heat Exchanger Bracket Screws
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.