LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> Engine Mechanical >> Lubrication System >> 17 - Engine - Lubrication -- 911 CARRERA (991) >> WM 174019 Removing And Installing Oil/Water Heat EXCHANGER (Except CARRERA "Edition", CARRERA Cabriolet "Edition", Turbo S, CARRERA 4 "Edition", Turbo CABRIO, Turbo S CABRIO, CARRERA 4 Cabriolet "Edition", Gt3, Gt3 RS) >> Installing Oil/Water Heat Exchanger

Installing Oil/Water Heat Exchanger

  1. Fit new sealing rings.
  2. Install oil/water heat exchanger -1-  .
    1. 2.1. Position oil/water heat exchanger on the bracket.

      Check that the sealing rings are at the correct position! 

    2. 2.2. Fit and tighten six screws -2-  . Tightening torque 10 Nm (7.5 ftlb.) 
    3. 2.3. Connect cable plug for oil pressure sender and clip in electric line.
      Fig 1: Identifying Heat Exchanger Threaded Joint
      G09990860Courtesy of PORSCHE CARS NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals