Neutral Gear Switch - Adaptation (Manual Transmission Only)

Necessary after: 

• Re-programming DME control unit
• Replacing DME control unit
• Deleting adaptation values (see above)

Necessary before: 

• Carrying out plausibility check on neutral gear switch to enable Start Stop system

How? 

1. Drive in 1st gear
   1. 1.1. Clutch released fully
   2. 1.2. Accelerate to around 30 km/h (20 mph)
   3. 1.3. Release accelerator pedal and allow vehicle to roll with gear engaged (engine overrun) up to around 10 km/h (6 mph)
2. Drive in 2nd gear
   1. 2.1. Clutch released fully
   2. 2.2. Accelerate to around 30 km/h (20 mph)
   3. 2.3. Release accelerator pedal and allow vehicle to roll with gear engaged (engine overrun) up to around 10 km/h (6 mph)
3. Vehicle is stationary
   1. 3.1. Clutch released fully
   2. 3.2. Shift lever in neutral position.

      Do not touch shift lever for 10 seconds 

4. Switch off ignition