LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> Engine Mechanical >> Exhaust >> 26 - Exhaust System -- 911 CARRERA (991) >> WM 261219 Removing And Installing Heat Shield (Except CARRERA "Edition", CARRERA Cabriolet "Edition", CARRERA 4 "Edition", TARGA 4, TARGA 4S, TARGA 4 GTS, CARR. 4 CABRIO, CARR. 4S CABRIO, Turbo CABRIO, CARR. 4 GTS CABRIO, Turbo S CABRIO, CARRERA 4 Cabriolet "Edition") >> Installing Heat Shield

Installing Heat Shield

Install heat shield. 

  1. Position upper or lower part of heat shield on the relevant cylinder head cover.
    1. 1.1. Secure the heat shield with two external Torx screws (M6 x 12) and tighten screws to the specified torque.

      → Tightening torque: 10 Nm (7.5 ftlb.) 



Information 

The procedure for removing and installing is described for one side as an example. The procedure for the other side is practically identical.

  1. Fit the heat shield -1-  using fastening screws -2-  and tighten screws.
    Fig 1: Identifying Heat Shield Screws (Cylinder Bank 4-6)
    G09991632Courtesy of PORSCHE CARS NORTH AMERICA, INC.


Information 

The procedure for removing and installing is described for one side as an example. The procedure for the other side is practically identical.

  1. Installation is performed in reverse order.
scientia non olet · About LEMON Manuals