| Top of radiator to body |
M8 x 50 |
Tightening torque |
23 Nm (17 ftlb.) |
|
|
| Bottom of radiator to body |
M8 x 25 |
Tightening torque |
23 Nm (17 ftlb.) |
|
|
| Radiator to body |
Screw, M8 x 30 |
Tightening torque |
23 Nm (17 ftlb.) |
|
|
| Radiator to body |
Screw, M8 x 50 |
Tightening torque |
23 Nm (17 ftlb.) |
|
|
| Holder for middle radiator |
Screw, M6 x 16 and M6 nut |
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|
| Holder for coolant pipes (front-axle carrier, rear) |
Screw, M6 x 45 |
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|
| Holder for coolant pipe (front-axle carrier, front) |
Screw, M6 x 35 |
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|
| Coolant pipe (front underbody) |
Screw, M6 x 12 |
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|
| Holder for coolant pipe (radiator connection) |
Screw, M6 x 35 |
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|
| Vacuum unit to disc valve holder (TMM) |
M4 x 12 |
Tightening torque |
3 Nm (2 ftlb.) |
|
|
| Disc valve holder to body (engine compartment) |
Collar nut, M6 |
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|
| Coolant reservoir to body |
Screw, M6 x 25 |
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|
| Temperature sensor in coolant pipe |
M14 x 1.5 - replace seal |
Tightening torque |
35 Nm (26 ftlb.) |
|
|
| Condenser to radiator module |
Fastening screw |
Tightening torque |
5 Nm (3.5 ftlb.) |
|
|
| Air-conditioning lines to condenser |
Fastening screws, M8 |
Tightening torque |
14 Nm (10.5 ftlb.) |
|
|