LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> 21 - Exhaust Gas Turbocharging -- 911 CARRERA (991) >> WM 214119 Removing And Installing Pressure Pipe (Turbo, Turbo S, Turbo CABRIO, Turbo S CABRIO) >> Removing Pressure Pipe

Removing Pressure Pipe

  1. Disconnect pressure pipe -1-  .
    1. 1.1. Loosen screw-type clamp -2-  on the throttle valve and pull off rubber sleeve.
    2. 1.2. Disconnect cable plug on boost pressure sensor -3-  .
    3. 1.3. Release and pull off vacuum lines -4-  .
    4. 1.4. Loosen clamps -arrows-  and pull off hose for acoustic simulator -6-  and vacuum hose -5-  .
      Fig 1: Locating Pressure Pipe Clamps (Upper Part)
      G09991339Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  2. Remove pressure pipe.
    1. 2.1. Loosen screw-type clamps -1-  and pull off pressure hoses -2-  .
    2. 2.2. Remove pressure pipe -3-  in an upward direction -arrow-  .
      Fig 2: Locating Pressure Pipe (Lower Part)
      G09991340Courtesy of PORSCHE CARS NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals