Installing Pressure Pipe

Install pressure pipe.
1. 1.1. Insert pressure pipe.
2. 1.2. Position and tighten outer screw-type clamps.
  Tightening torque 5.5 Nm (4 ftlb.)
  
  Fig 1: Locating Pressure Pipe (Lower Part)
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fit pressure pipe with rubber shroud for the throttle housing.
1. 2.1. Fit cable plug -3- , vacuum line -4- , vacuum hoses -5 and 6- and clamps -arrows- .
2. 2.2. Position screw-type clamp on rubber shroud for the throttle housing and tighten it.
  Tightening torque 5.5 Nm (4 ftlb.)
  
  Fig 2: Locating Pressure Pipe Clamps (Upper Part)
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.