Installing Turbocharger

Installation is performed in reverse order. Pay particular attention to the following:
1. 1.1. Replace exhaust manifold seal.
2. 1.2. Replace fastening nuts.
  Grease studs with MicroGLEIT LP 475 .
  
  Tightening torque for securing turbocharger to exhaust manifold:
  
  Tightening torque for securing turbocharger to top bracket:
  
  Information
  - Check O-rings on the plug-in couplings and replace them if necessary.
  - Clean plug connection and coolant hoses before assembly.
  - Coat O-rings and coolant hoses with Kluber Plus Gel (Part No. 000.043.205.93).
  - Remove stoppers before fitting the coolant lines and hoses.
3. 1.3. Replace O-rings on the coolant lines.
  Information
  - Replace O-rings.
  - Grease O-rings with a light coating of Kluber Syntheso Glep (Part No.: 000.043.204.68).
    Replace O-rings on the oil lines.
4. 1.4. Coolant lines to turbocharger:
5. 1.5. Oil lines to turbocharger:
6. 1.6. Tightening torque for exhaust temperature sensor:
  NOTE:
  Exhaust emissions temperature sensor fitted incorrectly
  - Risk of damage to components
  → Only use prescribed lubricant when installing the sensor.
  
  → Carefully check the thread for damage and smear the surface with Optimal MF Paste (Part No. 000.043.207.07).
  
  Grease thread with the prescribed lubricant.