Installing Rear Anti-Roll Bar

Information 

• Always replace fastening screws that are tightened to a torque angle. 
• Check anti-roll bar for corrosion and damage to the anti-roll-bar mounts. 
• Check suspension/stabilizer and PDCC actuator for damage and play. 

1. Screw two anti-roll bar clamps -1 and 2-  to the rear axle cross member.

   Tighten screws -3-  to Tightening torque 65 Nm (48 ftlb.)  .

   Tools: Open-end/ring wrench insert Nr.98-1 Pos.1  .

   Fig 1: Identifying Rear Axle Cross Member Anti-Roll Bar Screws

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. Fit the connecting link (suspension/stabilizer) to the anti-roll bar on both sides of the vehicle. Use new collar nuts.

   Initial tightening 40 Nm (30 ftlb.) Final tightening +30° 

   Fig 2: Installing Anti-Roll Bar

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.