Component And Assembly Overview
| No. | Designation | Qty. | Removal | Installation |
|---|---|---|---|---|
| -1- | Hexagon nut M14 x 1.5 | 1 | Before loosening the hexagon nut, pretension the coil spring with the spring tensioner. Loosen hexagon nut using Porsche special tool: socket-wrench insert 9630/2 or VW special tool: socket-wrench insert 3186 . Counter at the piston rod while loosening (and tightening). |
Use a new hexagon nut. Tightening torque 70 Nm (52 ftlb.) |
| -2- | Spring-strut mount | 1 | Identical parts on the left and right side | |
| -3- | Ball bearing | 1 | Replace if necessary. | |
| -4- | Tolerance compensation shim | 1 | Not always present. Observe allocation according to coil spring tolerance group (load group). This is described in the Assembly section (Information). |
|
| -5- | Spring plate, upper | 1 | Replace if necessary. | |
| -6- | Coil spring | 1 | Only available as a set. Observe allocation as per Spare Parts Catalogue. | |
| -7- | Bellows | 1 | Replace if necessary. | |
| -8- | Additional spring | 1 | Before installation, assemble at the correct position with No. -7- . | |
| -9- | Stop washer | 1 | Replace if necessary. | |
| -10- | Spring plate, lower | 1 | Replace if necessary. | |
| -11- | Vibration damper | 1 | Identical parts on the left and right side. Observe allocation as per Spare Parts Catalogue. | |
| -12- | Hexagon-head bolt, M10 x 55 | 1 | Only on vehicles with PDCC. | Tightening torque 46 Nm (34 ftlb.) |
| -13- | PDCC holder | 1 | Only on vehicles with PDCC. | Fit at the correct position on lower concave washer. |