| Connecting link (PDCC actuator) to anti-roll bar |
Collar nut, M12/always use new collar nut following removal |
Initial tightening |
50 Nm (37 ftlb.) |
|
|
| Connecting link (PDCC actuator) to anti-roll bar |
Collar nut, M12/always use new collar nut following removal |
Final tightening |
+50° |
|
|
| Connecting link (PDCC actuator) to wheel carrier |
Cheese head bolt with hexagon nut, M12 |
Initial tightening |
50 Nm (37 ftlb.) |
|
|
| Connecting link (PDCC actuator) to wheel carrier |
Cheese head bolt with hexagon nut, M12 |
Final tightening |
+50° |
|
|
| Hydraulic lines to connecting link (PDCC actuator) |
Banjo bolt, M12 x 1.5 |
Tightening torque |
26 Nm (19 ftlb.) |
|
|