Removing Rear Anti-Roll Bar

Detach the PDCC actuator from the anti-roll bar on both sides of the vehicle. Counter with a Torx wrench.

Fig 1: Removing Anti-Roll Bar
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Loosen four screws -3- on the anti-roll bar clamps -1 and 2- from the rear axle cross member.
Remove anti-roll bar (anti-roll bar assembly with anti-roll-bar mount and clamps).

Turn the anti-roll bar as required and remove it in a downwards direction.

Fig 2: Identifying Rear Axle Cross Member Anti-Roll Bar Screws
Courtesy of PORSCHE CARS NORTH AMERICA, INC.