Installing Rear Anti-Roll Bar

Install anti-roll bar -1- .
1. 1.1. Screw in M8 fastening screws for anti-roll bar clamps -4- .
  Tightening torque 25 Nm (19 ftlb.)
2. 1.2. Fit connecting links (suspension/stabilizer) in the central position on the anti-roll bar -arrow- .
  Use new collar nuts -2-.
  
  Initial tightening 40 Nm (30 ftlb.) Final tightening +30° .
  
  Fig 1: Identifying Anti-Roll Bar Mount
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  
  Fig 2: Locating Suspension/Stabilizer On Anti-Roll Bar Position
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.