Removing Rear Tie Rod (Toe Control Arm)

Mark position of eccentric washer -1- with respect to the rear-axle carrier side section (toe adjustment).
Then loosen the lock nut -2- on the toe control arm. Counter at the eccentric screw -3- at the same time.
1. Eccentric washer
2. Lock nut
3. Eccentric screw
  
  Fig 1: Identifying Eccentric Washer Marking Position
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Remove self-levelling sensor (height sensor).

Fig 2: Removing Self-Levelling Sensor
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 2.1. Unscrew fastening screw -1- from the self-levelling sensor holder.
2. 2.2. Unclip holder -A- and remove it from the rear-axle trailing arm.
Remove rear-axle carrier side section -1- together with the toe control arm -2- and trailing arms -3 und 4- .

Fig 3: Identifying Rear-Axle Carrier Side Section With Trailing Arms
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 3.1. Unscrew fastening screws -2- and fastening nuts -3- from the rear-axle carrier side section -1- .
  
  Fig 4: Identifying Rear-Axle Carrier Side Section
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. 3.2. Remove rear-axle carrier side section -1- by pulling it downwards.
Remove toe control arm -2- on the rear-axle carrier side section -1- .

Fig 5: Removing Toe Control Arm
Courtesy of PORSCHE CARS NORTH AMERICA, INC.