Installing Rear Tie Rod (Toe Control Arm)

Fit eccentric washer -4-  at the position marked (prior to removal).

Tighten lock nut -5-  to Tightening torque 100 Nm (74 ftlb.)  .

Fig 1: Installing Toe Control Arm

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Use a new lock nut and hexagon-head bolts. Observe the specified tightening torques/torque angles! 

Lock nut Initial tightening 90 Nm (67 ftlb.) Final tightening +90° 

Hexagon-head bolts Initial tightening 90 Nm (67 ftlb.) Final tightening +90°