| Wishbone to wheel carrier (ball joint) |
Lock nut, M12 x 1.5 |
Tightening torque |
85 Nm (63 ftlb.) |
|
|
| Tie rod to wheel carrier (ball joint) |
Lock nut, M12 x 1.5 |
Tightening torque |
85 Nm (63 ftlb.) |
|
|
| Spring strut to wheel carrier |
M12 x 1.5/conventional and PDCC |
Tightening torque |
85 Nm (63 ftlb.) |
|
|
| Spring-strut supporting mount to body |
Hexagon nut, M8 |
Tightening torque |
33 Nm (24 ftlb.) |
|
|
| Brake calliper to wheel carrier |
M12 x 1.5/always use new screws following removal |
Tightening torque |
85 Nm (63 ftlb.) |
|
|
| Drive shaft to wheel hub |
Lock nut, M22 x 1.5/always use new lock nuts following removal |
Tightening torque |
460 Nm (340 ftlb.) |
|
|
| Connecting link (PDCC actuator) to spring strut (actuator holder) |
Collar nut, M12 x 1.5/always use new collar nut following removal |
Initial tightening |
50 Nm (37 ftlb.) |
|
|