| Connecting link (PDCC actuator) to anti-roll bar |
Collar nut, M12 x 1.5/always use new collar nut following removal |
Initial tightening |
50 Nm (37 ftlb.) |
|
|
| Connecting link (PDCC actuator) to anti-roll bar |
Collar nut, M12 x 1.5/always use new collar nut following removal |
Final tightening |
+50° |
|
|
| Connecting link (PDCC actuator) to spring strut (actuator holder) |
Collar nut, M12 x 1.5/always use new collar nut following removal |
Initial tightening |
50 Nm (37 ftlb.) |
|
|
| Connecting link (PDCC actuator) to spring strut (actuator holder) |
Collar nut, M12 x 1.5/always use new collar nut following removal |
Final tightening |
+50° |
|
|
| Hydraulic lines to connecting link (PDCC actuator) |
Banjo bolt, M12 x 1.5 |
Tightening torque |
26 Nm (19 ftlb.) |
|
|
| Holder for fixing device for pressure lines to connecting link (PDCC actuator) |
Countersunk screw, M6 x 12 |
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|