| Anti-roll bar clamp to front-axle cross member (PDCC) |
Hexagon-head bolt, M10 x 60 + hexagon nut |
Tightening torque |
65 Nm (48 ftlb.) |
|
|
| Connecting link (PDCC actuator) to anti-roll bar |
Collar nut, M12 x 1.5/always use new collar nut following removal |
Initial tightening |
50 Nm (37 ftlb.) |
|
|
| Connecting link (PDCC actuator) to anti-roll bar |
Collar nut, M12 x 1.5/always use new collar nut following removal |
Final tightening |
+50° |
|
|
| Connecting link (conventional suspension/stabilizer) to anti-roll bar |
Collar nut, M10 x 1.5/always use new collar nut following removal |
Initial tightening |
40 Nm (30 ftlb.) |
|
|
| Connecting link (conventional suspension/stabilizer) to anti-roll bar |
Collar nut, M10 x 1.5/always use new collar nut following removal |
Final tightening |
+30° |
|
|