| Fastening screws for front-axle cross member, inner front |
M12 x 1.5 x 50 |
Tightening torque |
90 Nm (67 ftlb.) |
+90° |
|
| Fastening screws for front-axle cross member, outer front |
M12 x 1.5 x 105 |
Tightening torque |
90 Nm (67 ftlb.) |
+180° |
|
| Fastening nut on front-axle cross member, centre front |
M12 x 1.5 |
Tightening torque |
90 Nm (67 ftlb.) |
+90° |
|
| Fastening screws securing holder for coolant pipes to front-axle cross member |
M6 x 20 |
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|
| Fastening screws securing front-axle cross member and longitudinal strut to body |
M12 x 1.5 x 58 |
Tightening torque |
90 Nm (67 ftlb.) |
+ 90° |
|
| Fastening nut securing longitudinal strut to body |
M10 |
Tightening torque |
65 Nm (48 ftlb.) |
|
|
| Stud securing front final drive to front-axle cross member |
Stud, M10 x 105 |
Tightening torque |
17 Nm (13 ftlb.) |
|
|
| Bracket securing front final drive to front-axle cross member |
Hexagon nut, M10 |
Tightening torque |
65 Nm (48 ftlb.) |
|
|
| Fastening screw securing universal joint at the bottom to steering gear |
M8 x 30 |
Tightening torque |
20 Nm (15 ftlb.) |
+90° |
|
| Fastening nut securing connecting link to anti-roll bar |
M10 x 1.5 |
Tightening torque |
40 Nm (30 ftlb.) |
+30° |
|
| Fastening nut securing PDCC actuator to anti-roll bar |
M12 x 1.5 |
Tightening torque |
50 Nm (37 ftlb.) |
+50° |
|
| Fastening nut securing front-axle wishbone to wheel carrier |
M12 x 1.5 |
Tightening torque |
85 Nm (63 ftlb.) |
|
|
| Fastening nut securing tie rod to wheel carrier |
M12 x 1.5 |
Tightening torque |
85 Nm (63 ftlb.) |
|
|
| Fastening screw securing bracket for height sensor and coolant pipe to front-axle cross member |
M6 x 45 |
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|
| Fastening nut securing sub-frame (front-axle support) to body |
M10 |
Tightening torque |
65 Nm (48 ftlb.) |
|
|
| Fastening screw securing coolant pipes to front-axle support |
M6 x 15 |
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|