Installing Front Wheel Housing Liner (Front Part)

Installation is performed in reverse order. Pay particular attention to the following: 

1. Tighten fastening screws to the specified torque.
   1. 1.1. Upper part of front wheel housing liner (front part) Tightening torque 3.2 Nm (2 ftlb.) +10 % -15 % Tightening torque 2 Nm (1.5 ftlb.) +10 % -15 % 
   2. 1.2. Air vane Tightening torque 3.2 Nm (2 ftlb.) +10 % -15 % 
   3. 1.3. Lower part of front wheel housing liner (front part) Tightening torque 3.2 Nm (2 ftlb.) +10 % -15 %