LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> Collision >> Body Panels >> 50 - Body Front - 911 CARRERA (991) >> WM 501455 Replacing Front Panel (Except CARRERA "Edition", CARRERA Cabriolet "Edition", Turbo S, CARRERA 4 "Edition", CARRERA 4 Cabriolet "Edition") >> Subsequent Work >> Subsequent Work For Body Repairs (With Straightening System)

Subsequent Work For Body Repairs (With Straightening System)

  1. Remove vehicle from the straightening system.
  2. Clean joint areas and sheetmetal flanges with a wire brush.
  3. Prime joint areas and sheetmetal flanges with 2K primer.
  4. Restore standard seal with body sealant → WM 5X00IN SEAM SEALS (EXCEPT CARRERA "EDITION", CARRERA CABRIOLET "EDITION", CARRERA 4 "EDITION", TARGA 4, TARGA 4S, TARGA 4 GTS, CARRERA 4 CABRIOLET "EDITION") .

    Also seal the repair area carefully.

  5. Paint repair area and adjacent surfaces, if necessary.
  6. Restore standard underbody protection with underbody sealant → WM 5X00IN UNDERBODY PROTECTION (EXCEPT CARRERA "EDITION", CARRERA CABRIOLET "EDITION", CARRERA 4 "EDITION", TARGA 4, TARGA 4S, TARGA 4 GTS, CARRERA 4 CABRIOLET "EDITION") 5X00IN43
  7. Apply standard cavity preservation → WM 5X00IN CAVITY PRESERVATION (EXCEPT CARRERA "EDITION", CARRERA CABRIOLET "EDITION", CARRERA 4 "EDITION", TARGA 4, TARGA 4S, TARGA 4 GTS, CARRERA 4 CABRIOLET "EDITION") . Also carefully apply cavity preservation to the repair area.
  8. Install removed accessories in the repair area.
scientia non olet · About LEMON Manuals