Installing Spreader Device

Information 

If a new actuator was installed, this must be confirmed in PIWIS Tester II 9818  .

• >>Control unit overview<< >>Parking brake<< >>Drive links/checks<< >>Confirm actuator replacement<<. 

1. NOTE: Do not twist the brake shoe mountings when installing the actuator!
2. If using the same actuator again:
   1. 2.1. Clean the spreader device carefully so as not to damage the dust boots.
   2. 2.2. Visually inspect the dust boots for cracks.
3. Tighten new fastening screws on the spreader device -arrows-  . Initial tightening 10 Nm (7.5 ftlb.) Final tightening +60°  .
   Fig 1: Locating Actuator Mounting Fastening Screws

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
4. Tighten fastening screws on brake cover plate. Tightening torque 10 Nm (7.5 ftlb.)  .
5. Plug in electric plug connection -2-  for the actuator -1-  (-A-  ) and lock it -a-  .

   Clip wire harness -4-  into the retaining clip -3-  (-B-  ).

   Fig 2: Installing Plug Connection

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.