Installing Parking-Brake Shoes

Observe correct tightening torques.

1. Remove tie-wrap -2-  on actuator -1-  for parking brake.
   Fig 1: Identifying Actuator (Servo Motor) For Parking Brake Secured With Tie-Wrap

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
   WARNING: Preloaded or pressurized components

   • Risk of injury (e.g. crushing or bruising) when removing and installing springs.

   → Do not reach into the danger area.

   → Relieve the tension on components before starting work.

   → Secure components to prevent them from loosening suddenly.

   → Wear protective gloves and goggles.

   → Be very careful when working on the brake system.

2. The parking-brake shoes -1-  are installed in reverse order.
   Fig 2: Identifying Brake Shoe Components

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
   1. 2.1. Fit parking-brake shoes with adjustment device -1 and 3-  .
   2. 2.2. Engage both tension springs -4 and 5-  .
   3. 2.3. Install compression springs -2-  .
   4. 2.4. Centre the entire unit.