Installing Hinge For Convertible-Top Compartment Lid

Information 

Check that the water drip pan is seated correctly close to the rear water drain.

1. Prime the sealing surfaces of the hinge on the body using a corrosion protection touch-up stick.
2. Position the hinge at the previously marked area and tighten fastening nuts and fastening screw.
3. Install hydraulic cylinder for convertible-top compartment lid.
4. Clip in wiring harness for convertible-top compartment lid.
5. Tighten fastening nuts to Tightening torque 23 Nm (17 ftlb.)  .
6. Tighten fastening screw to Tightening torque 23 Nm (17 ftlb.)  .