Removing Additional Flap (Module)

Fig 1: Locating Additional Flap Position (Module)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Perform emergency operation of additional flaps as described in the Driver's Manual.
1. 1.1. Loosen motor.
2. 1.2. Move additional flaps to the open position.
Disconnect plug connection for motor.

Fig 2: Disconnecting Wiring Harness Plug Connection
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Unclip connector housing.

Fig 3: Identifying Connector Housing
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Information

Screw is accessible through the cut-out in the additional flap.

Fig 4: Locating Threaded Joint Of Additional Flap
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Unscrew and remove fastening screws at the sides.

Fig 5: Locating Side Screws Of Additional Flap
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Unscrew fastening screws at the top.

Fig 6: Identifying Screws Of Additional Flap
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Unscrew rear fastening screws.

Fig 7: Identifying Rear Fastening Screws
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Pull additional flaps with drive mechanism up and off.
Feed out belt strap.

Fig 8: Pulling Out Belt Strap
Courtesy of PORSCHE CARS NORTH AMERICA, INC.