Removing Additional Flap: Notes
- Perform emergency operation of additional flaps as described in the Driver's Manual.
- 1.1. Loosen motor.
- 1.2. Move additional flaps to the open position.
- Disconnect plug connection for motor.
Information
Screw is accessible through the cut-out in the additional flap.
- Unscrew and remove fastening screws on the guide flaps.
Information
- The illustrations for the procedure show only one side of the vehicle.
- All steps must also be completed on the opposite side of the vehicle.
- These must be carried out as a mirror image of the steps shown.
- Unclip wire harness.
- Remove additional flaps.
- 5.1. Press off clip connection at the drive -arrow A- .
- 5.2. Pull additional flaps with drive up and off -arrow B- .
- Remove drive mechanism.
- 6.1. Loosen clamp -2- .
- 6.2. Pull additional flap -1- with actuating cable off the drive.
- Disassemble additional flap
- 7.1. Press additional flap -1- down in the guide rail -2- .
- 7.2. Press lever out of the guide track -arrow- .
- 7.3. Pull additional flap -1- fully out of the guide rail -2- .