Installing Convertible Top Covering

Fig 1: Securing Convertible Top Covering

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

1. 1.1. Position convertible top covering -1-  .
   Fig 2: Positioning Convertible Top Covering

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
   1. 1.1.1. Fit reinforcement strip -2-  around the roof frame -3-  on the inside -arrow-  .
2. 1.2. Fit the corners. -arrows A- 
3. 1.3. Align convertible top covering -1-  at the front with the markings -arrows-  so that it is centered.
   Fig 3: Aligning Convertible Top Covering

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
4. 1.4. Fold the convertible fop material around the edge of the roof frame without wrinkles. -arrows B- 
5. 1.5. Secure the front edge with double-sided adhesive tape -2-  .

Fig 4: Identifying Stick On Felt Strip

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Information 

The nuts -2-  on the retaining frame -1-  must be positioned flush with the lower edge. -arrows- 

Fig 5: Positioning Retaining Frame For Rear Window

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Align the convertible top covering -1-  with the marking -2-  so that it is centered with respect to the bore on the tension bow -3-  . -arrows- 

Fig 6: Positioning Convertible Top Covering

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Further installation is performed in reverse order to removal.

Tightening torque 9.7 Nm (7.5 ftlb.) 

Tightening torque 9.7 Nm (7.5 ftlb.)